Edimax Technology ER-5390S user manual Connecting to network devices with coaxial cables

Page 10

4. Connecting to network devices with coaxial cables

Attach the T-connector to the BNC port on the rear panel and connect the coaxial cables to the both open ends of the T-connector as illustrated in Figure 5-2. If the ER-5390S is at either end of the coaxial segment, make sure terminate the open end of T-connector with a 50-ohm terminator.

Note : Do not connect coaxial cable directly to the BNC port without using T- connector.

OUT

IN

Uplink

8

7

6

5

4

3

2

1

Figure 5-2 connect the coaxial cables

5. Connecting the power

Connect the DC power jack to the DC power socket on the rear panel of the hub. Connect the power adapter to the power outlet. The green Power LED on the front panel should be lit.

Uplink

8

7

6

5

4

3

2

1

Figure 5-3 Connect the external power adapter

7

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Ethernet Hub FCC Compliance Statement Contents Introduction ER-5390S TopologyFeatures SpecificationPackage Contents Physical Description PanelLED LEDOperating Environment InstallationConnecting to network devices with UTP cable Uplink to Another Hub with UTP cableConnecting to network devices with coaxial cables Connecting the powerPower LED is not lit Trouble-shootingPartition LED is lit Contact your dealer if problem persist Collision LED is constantly flashing
Top Page Image Contents