Edimax Technology ES-5224RS+ user manual Media type NWay Speed Duplex

Page 40

User Manual

Default is Enable.

Auto Negotiate:

Only “Enable” and “Disable” two states can be chosen. “Enable” means the port adopted the auto-negotiation algorithm to exchange the capability with the linked partner and adjusted its speed, duplex and flow control. When enabled, the speed, duplex mode and flow control mode may change. “Disable” means the forced mode is adopted. When disabled, if you want to set up a connection successfully, you must have both port configuration of local port and linked partner be the same. If their configuration is different, the link will not be set up successfully. In the switch, the 1Gbps fiber module, it supports auto and forced modes.

Default: Auto Negotiation is enabled.

Notice: When you are in Disable mode, you must handle it carefully because this may cause the connection failed.

Speed Duplex:

Set the speed and duplex of the port. In speed, 10/100Mbps baud rate is available for Fast Ethernet, Gigabit module in port 25, 26. If the media is 1Gbps fiber, it is always 1000Mbps and the duplex is full only. If the media is TP, the Speed/Duplex is comprised of the combination of speed mode, 10/100/1000Mbps, and duplex mode, full duplex and half duplex. The following table summarized the function the media supports.

Media type

 

NWay

 

Speed

 

Duplex

 

100M TP

 

ON/OFF

 

10/100M

 

Full/Half

1000M TP

 

ON/OFF

 

10/100/1000M

 

Full for all, Half for 10/100

1000M Fiber

 

ON/OFF

 

1000M

 

Full

In Auto-negotiation mode, no default value. In Forced mode, default value depends on your setting.

Flow Control:

There are two modes to choose in flow control, including Enable and Disable. If flow control is set Enable, both parties can send PAUSE frame to the transmitting device(s) if the receiving port is too busy to handle. When it is set Disable, there will be no flow control in the port. It drops the packet if too much to handle.

Default: Enable

Publication date: July, 2006

Revision A2

34

Image 40
Contents ES-5224RS+ Page Release Table of Contents Maintenance Appendix a Technical SpecificationsElectronic Emission Notices Federal Communications Commission FCC StatementAbout this user’s manual Key Features in the Device Overview of 24 Fast Ethernet + 2 Gigabit Web-Smart SwitchModel Description Checklist FeaturesHardware ManagementPublication date July View of 24 Fast Ethernet + 2 Gigabit Web-Smart Switch User Interfaces on the Front Panel Button, LEDs and PlugsLED Indicators System LED10/100Mbps Ethernet TP Port 1 to 24 LED 10/100/1000Mbps Gigabit TP/Fiber Port 25, 26 LEDRear View of 24 Fast Ethernet +2 Gigabit Web-Smart Switch User Interfaces on the Rear PanelView of the Optional Modules Front View of 1000Base-SX/LX LC, SFP Fiber TransceiverHardware and Cable Installation Starting Web-Smart Switch UpConnecting the SFP Module to the Chassis Power On TP Port and Cable InstallationFirmware Loading Installing Chassis to a 19-Inch Wiring Closet Rail Cabling RequirementsCabling Requirements for TP Ports Cabling Requirements for 1000SX/LX SFP Module1000Base-X TP, Fiber 100Base-TX TP Typical Network Topology in DeploymentNo Vlan Configuration Diagram Case 2b Port-based Vlan See -5 Configuring the Management Agent of Web-Smart Switch Managing Web-Smart Switch through Ethernet Port Login Screen for Web IP Address Assignment110 10000000.00000001.00000010.1 Prefix Length No. of IP matched No. of Addressable IP Publication date July Typical Applications 11 Network Connection between Remote Site and Central Site12 Peer-to-peer Network Connection Operation of Web-based Management Web Management Home Overview Information of Page Layout Root System Port IP Configuration System Parameter DescriptionPublication date July Publication date July Revision A2 Port Parameter description for Port Configuration Media type NWay Speed Duplex Publication date July Revision A2 IP Configuration Publication date July Revision A2 Vlan Publication date July Revision A2 Port-based Vlan Publication date July Revision A2 Publication date July Vidvlan ID Publication date July Publication date July Revision A2 Pvid Publication date July Revision A2 Trunking Parameter description Mirror Publication date July Revision A2 QoS Publication date July Revision A2 Rate Publication date July Revision A2 Trap Events Isolated Group Restore Default Reboot Logout Resolving No Link Condition Q&AAppendix a Technical Specifications Publication date July Revision A2 ƒ Network Interface of Option transceiver ƒ Cable and Maximum Lengthƒ Diagnostic LED ƒ Power RequirementAmbient Temperature DimensionsManagement Software Specifications