CyberPower Systems RMCARD201 manual IP setup using Snmp Card Configuration Tool program

Page 3

CyberPower Network Management System

In this section, it will be introducing the “SNMP Card Configuration Tool” program.

If a DHCP network service is not available or you want to assign a new IP Address to the SNMP card, please follow the steps listed below:

I. IP setup using “SNMP Card Configuration Tool” program:

1.Please run the “wsnmpcfg” program in the “All Programs”->“SNMP Card Configuration Tool”.

2.The main dialog of the “SNMP Card Configuration Tool” program is shown as Figure. 2. The User can obtain information of the SNMP card through the GUI.

3.The "Refresh" button is used to search the entire SNMP card device in local network.

Figure 2. The main dialog of the “SNMP Card Configuration Tool” program.

4. Then choose the 「Setup as selected」 under 「Tool」 menu or double click the SNMP card device.

5.You can modify the new IP, new subnet mask, and new gateway address through the IP or MAC address in the SNMP card setting dialog, as shown in figure 3.

Figure 3. The SNMP card setting dialog.

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents CyberPower Network Management System Rev.1.2 Setup the IP address for the Snmp Card Hardware and Tool InstallationsMain dialog of the Snmp Card Configuration Tool program IP setup using Snmp Card Configuration Tool programAuthentication dialog Web Browser II. IP setup using Command Line command Locate the subnet of CyberPower Network Management Card Select an IP Address for CyberPower Network Management CardCyberPower Network Management System
Top Page Image Contents