Cypress STK11C88 manual Software STORE/RECALL Mode Selection A13 A0, 0x0E38 Read Sram Output Data

						STK11C88
Table 2. Software STORE/RECALL Mode Selection
	CE	WE	A13 – A0	Mode	IO	Notes
	L	H	0x0E38	Read SRAM	Output Data	[1, 2]
			0x31C7	Read SRAM	Output Data
			0x03E0	Read SRAM	Output Data
			0x3C1F	Read SRAM	Output Data
			0x303F	Read SRAM	Output Data
			0x0FC0	Nonvolatile STORE	Output Data
	L	H	0x0E38	Read SRAM	Output Data	[1, 2]
			0x31C7	Read SRAM	Output Data
			0x03E0	Read SRAM	Output Data
			0x3C1F	Read SRAM	Output Data
			0x303F	Read SRAM	Output Data
			0x0C63	Nonvolatile RECALL	Output Data

Notes

1.The six consecutive addresses must be in the order listed. WE must be high during all six consecutive CE controlled cycles to enable a nonvolatile cycle.

2.While there are 15 addresses on the STK11C88, only the lower 14 are used to control software modes.

Document Number: 001-50591 Rev. ** Page 5 of 15

[+] Feedback