Installing the player

English

1.Identify what the polarity the vehicle Dome Light circuit is. * Refer to section 6 : "9. Polarity Switch" on Page 16 and set this switch correctly.

2.To prevent short circuits, remove the key from the ignition and disconnect he terminal of battery.

3.Disconnect the original dome light.

4.Attach the metal mounting plate to the roof Using the ST4.2*16 screws.

Note: Do not to cover the original dome light opening.

5.Pull out the original dome light Power wire and signal/power cable through the original dome light opening.

6.Place the rubber on the player surround

7.Connect input and output cables.

8.Connect the wire harness in the following or- der: Ground wire (Black), Battery wire (Yellow), +ACC wire (Red) and Door wire (Green).

9.Attach the DVD player to the metal mounting plate using the CM 4x10 screws.

10. Reconnect the terminal of the battery.

Notes:

•Remember to connect the red wire to the ACC of the ignition switch. Or the battery charge might be drained prematurely.

•If the fuse is opened, first make sure that the cables have not caused a short circuit, and then replace the old fuse with a new one of the same ratings.

•Do not have unconnected cables or termi- nals touch the metal on the car or any other conducting material.

•To prevent short circuits, do not remove the caps from unused terminals or from the ends of the unconnected cables.

•After the display unit is installed, check and make sure the brake lights, blinkers, wiper, etc. on the vehicle are working properly.

•Insulate unconnected wires with vinyl tape or other similar material.

•Make sure that cords and other items do not get caught in the panel when you close it.

For your safety, be sure to close the LCD panel when not use it.

OHM107VD 17