Channel Vision, Features | Channel Vision IR-2005 instruction

CD player

CHANNEL VISION

Limited Warranty

Channel Vision Technology will repair or replace any defect in material or workmanship which occurs during normal use of this product with new or rebuilt parts, free of charge in the USA, for two years from the date of original purchase. This is a no hassle warranty with no mail in warranty card needed. This warranty does not cover damages in shipment, failures caused by other products not supplied by Channel Vision Technology, or failures due to accident, misuse, abuse, or alteration of the equipment. This warranty is extended only to the original purchaser, and a purchase receipt, invoice, or other proof of original purchase date will be required before warranty repairs are provided.

Mail in service can be obtained during the warranty period by calling (800) 840- 0288 toll free. A Return Authorization number must be obtained in advance and can be marked on the outside of the shipping carton.

This warranty gives you specific legal rights and you may have other rights (which vary from state to state). If a problem with this product develops during or after the warranty period, please contact Channel Vision Technology, your dealer or any factory-authorized service center.

500-181 rev A

The IR-2005 includes these items:

IR-2005

(rear view)	Screwless decorator style trim ring
(rear view)
	Single-gang decorator style IR wall plate

IR-2400 Plasma proof IR receiver

IR-2005

(front view)

How IR repeating works

The IR receiver is wired to the IR hub which routes the signal to IR emitters

Specifications (typical)

Voltage requirements:	8 - 12 VDC
IR Freq. range supported:	30 kHz - 60 kHz
IR pickup range:	40 ft. @ 38kHz, 25 ft. @ 56kHz
Mounting requirements:	Single-gang box or ring

sion
Expan
	Zone
lobal
PwrG	Model
IR	Model
	P-1205
Receiver
	CHANNEL
	VISION
		l
		Globa
	IR vier
	Rece
		Zon	e
		C
	+ 12D
	25	0mA

		3
	2	6
1	5	9
	4	8
	7	0

Point an IR remote control at the IR receiver

And the emitter repeats the IR signal in the other room.

Color:

White

Specifications subject to change without notice.

IR receiver window

Features:

Plasma Proof IR receiver

Status LEDs for IR signal indication

Mounts in a single-gang box or low-voltage ring

Be sure the emitter is attached directly over the component’s IR receiver. To locate the IR receiver, shine a flashlight into the unit and look for the sensor.