REMOTE CONTROL
The 840A is supplied with an Azur Navigator remote control that operates both this amplifier and Cambridge Audio Azur CD players. Insert the supplied AAA batteries to activate.
The 840A/C remote control comes with an Amplifier Control button, that when pressed, puts the remote into Amp mode, allowing operation of the 840A. When pressed, the LED will light up for 7 seconds (to let you know you are in Amp mode), and will then flash when one of the circled Amp buttons is pressed. All other remote buttons are inactive when in Amp mode.
The functions relevant to the amplifier are as follows:
Standby/On
Switches the amplifier between On and Standby mode.
Numerical buttons 1-8
Press to change the input source to the amplifier. Button 8 toggles Tape Monitor on/off.
Mode Mode
Press to switch between Volume and Balance modes.
Prog
Amp Mode
Control
Vol
Vol
MenuSelect
Repeat A - B Remain
Intro Random Space
Speaker
A/B
Mute
Mutes the audio on the amplifier. The mute mode is indicated by MUTE appearing and the volume level being replaced by two flashing dashes in the display. Press again to cancel mute.
Volume
Increase or decrease the volume of the amplifier output.
SpeakerA/B Speaker A/B
Press to scroll through the speaker sets connected to the loudspeaker terminals on the back panel (speaker sets A, B or A and B).
Bright
Adjust the backlight of the front panel display; bright, dim or off.
To exit Amp mode (and return to CD mode), press the Amp Control button again (the LED will light up for one second).
10Azur Class XD integrated amplifier