Edimax Technology BR-6218Mg user manual 2d Windows NT

Page 10

2d) Windows NT

1:Click the Start button and select Settings, then click Control Panel. The Control Panel window will appear.

2:Double-click Network icon. The Network window will appear. Select the Protocol tab from the Network window.

3:Check if the TCP/IP Protocol is on your list of Network Protocols. If TCP/IP is not installed, click the Add button to install it now. If TCP/IP is installed, go to step 5.

4:In the Select Network Protocol window, select the TCP/IP Protocol and click the Ok button to start installing the TCP/IP protocol. You may need your Windows CD to complete the installation.

5:After you install TCP/IP, go back to the Network window. Select TCP/IP from the list of Network Protocols and then click the Properties button.

6:Check each of the tabs and verify the following settings:

•IP Address: Select Obtain an IP address from a DHCP server.

•DNS: Let all fields are blank.

•WINS: Let all fields are blank.

•Routing: Let all fields are blank.

7:Click OK to confirm the setting. Your PC will now obtain an IP address automatically from your Broadband Router’s DHCP server.

Note: Please make sure that the Broadband router’s DHCP server is the only DHCP server available on your LAN.

Once you’ve configured your PC to obtain an IP address automatically, please proceed to Step 3.

9

Page 9 Page 11
Image 10
Page 9 Page 11
Contents User’s Manual Page Page Introduction FeaturesPackage Content Minimum RequirementsFront Panel ResetGet to know the Broadband Router Back Panel Local Area Network LANSetup Diagram Light Status DescriptionGetting started Configure your PC to obtain an IP address automaticallyDNS Configuration Select Disable DNS 2a Windows 95/98/Me2b Windows XP 2c Windows 2d Windows NT IP Address Select Obtain an IP address from a Dhcp serverPage Status Information ToolsChapter Quick Setup Time ZonePptp WAN SettingsL2TP Dynamic IP PPPoE Static IP AddressDNS MTU PptpISP BEZEQ-ISRAEL L2TP LAN General SettingsWAN NATSystem Settings SystemPassword Settings Remote Management Dhcp WANStatic IP PPPoE PPP over Ethernet5 L2TP DdnsLAN Basic Settings WirelessAP Mode setting Page AP Bridge-WDS mode setting Advanced SettingsSsid WMM WEP only Security3.2 802.1x only 3.3 802.1x WEP Static key Wpatkip 3.4 WPA/WPA2 Pre-shared keyWPA2AES 3.5 WPA/WPA2 Radius Access Control QoS Port-based QoS Rate Policing QoS Guaranteed / Spare Class QoS NAT Virtual Server Example Virtual ServerSpecial Applications MSN TCP Example Special ApplicationsExample UDPALG Settings UPnP SettingsStatic Routing Firewall Access Control List Example Access Control URL Filter Anti-DoS Denial of Service 4 DMZ Chapter Status Logs Status and InformationSystem Log ACL Log URL Filter Log DoS Log New Connection Log Chapter Tool How to Manually find your PC’s IP and MAC address Appendix aGlossary Snmp UCP TCP FTP Smtp POP3Http TCP Pptp
Top Page Image Contents