First Virtual Communications PS1010-3A user manual Viewing firmware version

Page 7

5.4.2Measuring voltages at external sources

•Put VM/Vout switch [(10)] to VM position. VM LED indicator [(4)] will light up

•Connect wires as shown below(VM terminal and the GND of Vout terminals)

•Value will be displayed [(2)].

•Switch OFF the PS1010 [(1)]

•Put VM/Vout switch [(10)] to VM position

•Press and hold the C-SET button

IBBI Electronics

Image 7

Contents PS1010-3A Table of Contents Device overview Safety precautionsGetting started Operating conditions Viewing actual current flow Setting output voltageSetting current limit Device operationDUT Voltmeter modeMeasuring voltages at external sources Viewing firmware versionTroubleshooting General information Warranty terms and conditionsWeb http//ibbi.electronics.googlepages.com