B&B Electronics UNO-2170 user manual Inserting a CompactFlash Card, Chassis Grounding

Page 24

Chapter 3 Initial Setup

3.1 Inserting a CompactFlash Card

The procedure for installing a CompactFlash™ card into the UNO-2170 is detailed below, please follow these steps carefully.

1.Remove the power cord.

2.Unscrew the four screws from the rear panel of the UNO-2170.

3.Remove the rear panel.

4.Plug a CompactFlash™ card with your OS and application program into a CompactFlash™ card slot on board.

5.Screw back the rear panel with four screws.

Note The CompactFlash™ slot is allocated as“Secondary IDE Master＂

3.2 Chassis Grounding

The aluminum made UNO-2170 provides good EMI protection and a stable grounding base. There is an easy-to-connect chassis grounding point for you to use.

Please connect chassis ground of UNO-2170 with "EARTH" as ground.

Figure 3.1: Chassis Grounding Connection

UNO-2170 User Manual

18

Image 24

Contents UNO-2170 Support Product Warranty Page Contents Appendix Programming the Watchdog Timer System Settings and Pin AssignmentsAppendix Overview Introduction Hardware Specifications Relative humidity 95% @ 40C Weight 1.6 kgSafety Precautions Always ground yourself to remove any static electricChassis Dimensions Chassis DimensionsPage Hardware Functionality RS-232 Interface COM1~COM2 Front panel of UNO-2170RS-232/422/485 Interface COM3~COM4 1 16C550 UARTs with 16-byte standard2 RS-422/485 detection Automatic Data Flow Control Function for RS-485RS-422/485 jumper setting 5 RS-232/422/485 SelectionPage IRQ and Address Setting Vector address for share IRQ 1D0HLAN Ethernet Connector Power ConnectorPS/2 Keyboard and Mouse Connector USB ConnectorVGA Display Connector Pcmcia PC Card SlotBattery Backup Sram Reset ButtonLithium Battery Specification Page Initial Setup Inserting a CompactFlash Card Chassis GroundingConnecting Power Installing a Hard DiskBios Setup and System Assignments Page System Settings Pin Assignments Appendix a System Settings and Pin Assignments 1SystemI/OAddressandInterruptAssignmentTable A.2 UNO-2170 Interrupt Assignment Board Connectors and Jumpers Figure A.2 UNO-2170 connector and jumper locations back-sideTable A.3 UNO-2170 Connectors and Jumpers RS-232 Standard Serial Port COM1~COM2 Ethernet RJ-45 Connector LAN1~LAN2 RS-232/422/485 Serial Port COM3~COM4Phoenix Power Connector PWR USB Connector USB1~USB2 Page Programming Watchdog Timer Appendix B Programming the Watchdog Timer AppendixB