B&B Electronics UNO-2170 user manual Board Connectors and Jumpers

Page 30

A.2 Board Connectors and Jumpers

There are several connectors and jumpers on the UNO-2170 board. The following sections tell you how to configure the UNO-2170 hardware setting. Figure A-1 and Figure A-2 show the locations of UNO-2170’s connectors and jumpers.

Figure A.1: UNO-2170 connector and jumper locations (front-side)

Figure A.2: UNO-2170 connector and jumper locations (back-side)

UNO-2170 User Manual

24

Image 30

Contents UNO-2170 Support Product Warranty Page Contents Appendix Programming the Watchdog Timer System Settings and Pin AssignmentsAppendix Overview Introduction Hardware Specifications Relative humidity 95% @ 40C Weight 1.6 kgSafety Precautions Always ground yourself to remove any static electricChassis Dimensions Chassis DimensionsPage Hardware Functionality RS-232 Interface COM1~COM2 Front panel of UNO-21702 RS-422/485 detection RS-232/422/485 Interface COM3~COM41 16C550 UARTs with 16-byte standard Automatic Data Flow Control Function for RS-485RS-422/485 jumper setting 5 RS-232/422/485 SelectionPage IRQ and Address Setting Vector address for share IRQ 1D0HPS/2 Keyboard and Mouse Connector LAN Ethernet ConnectorPower Connector USB ConnectorVGA Display Connector Pcmcia PC Card SlotBattery Backup Sram Reset ButtonLithium Battery Specification Page Initial Setup Inserting a CompactFlash Card Chassis GroundingConnecting Power Installing a Hard DiskBios Setup and System Assignments Page System Settings Pin Assignments Appendix a System Settings and Pin Assignments 1SystemI/OAddressandInterruptAssignmentTable A.2 UNO-2170 Interrupt Assignment Board Connectors and Jumpers Figure A.2 UNO-2170 connector and jumper locations back-sideTable A.3 UNO-2170 Connectors and Jumpers RS-232 Standard Serial Port COM1~COM2 Ethernet RJ-45 Connector LAN1~LAN2 RS-232/422/485 Serial Port COM3~COM4Phoenix Power Connector PWR USB Connector USB1~USB2 Page Programming Watchdog Timer Appendix B Programming the Watchdog Timer AppendixB