Hardware Installation

Below are the steps necessary to install a NetBlaster adapter into a standard, PMC compliant system. The following are detailed instructions for the hardware installation procedure.

Installing the Hardware

This installation procedure is for installing NetBlaster PMC adapter systems with an embedded PMC slot. Some steps in this procedure may vary depending on the specific system used. Refer to the system’s documentation if necessary.

The figure on the following page shows the installation of an adapter in a typical system.

!Observe proper Electro-Static Discharge prevention procedures at all times. Failure to do so may result in damage to the PCI Adapter or to the system.

0 I

CPCI PMC Carrier Card	!
	!
	Do not use excessive
	force.
Zx222 PMC Adapter

1.Turn off your system.

2.Discharge any static electricity from your body by touching the metal chassis, or by using an anti-static wrist strap. If you do not have a ground strap, maintain physical contact with the case to maintain the same electrical potential with the system.

3.Remove the motherboard or carrier card containing at least one available single-wide PMC slot. Select a slot to install the ZNYX Networks NetBlaster adapter. Remove the cover from the PMC slot.

ZNYX Networks NetBlaster ZX222 PMC Fast Ethernet Adapter · User’s Guide

Page 4