Preparing Your Receiver
Using One Remote Control for More than One Unit
Note: When you plug the cable into a component’s CONTROL IN jack, that component’s remote sensor does not function.
| CONTROL |
IN | IN |
OUT | OUT |
| |
CONTROL |
|
Receiver | Other Component |
| with OSR Mark |
If you also have an Optimus professional series CD player, VCR, or cassette deck with the OSR mark, you can connect its CONTROL IN jack to the receiver so you can control all of your equipment with a single remote control. You can also use the other component’s remote control by pointing it at the receiver’s front panel.
1.Connect each component to the receiver as shown in “Connecting Pro- gram Sources” on Page 8.
Note: You must connect the audio cables between the receiver and the other audio accessory to use your receiver’s remote control to control the accessory.
2.Connect the cable supplied with the CD player, VCR, or cassette deck between the receiver’s CONTROL OUT jack and the other component’s
CONTROL IN jack.
3.When you want to control more than one other component using the receiver’s remote control,
To the CONTROL IN ja of Another Componen Having the OSR Mark
Remote
Control
Installing the
Remote Control’s Batteries
Cautions:
•Use only fresh batteries of the recom- mended size and type.
•Always remove old or weak batteries. Batteries can leak chemicals that can damage electronic circuits.
The remote control uses two AA batteries (not included). For the longest battery life, we recommend RadioShack’s alkaline batteries (Cat. No.
1.Press and open the battery compartment cover.
2. Place two fresh AA batteries in the compartment as indicated by the polarity symbols (+ and
Note: If the remote’s range is reduced, replace the batteries immediately.
3.Replace the battery compartment cover.
12