Buffalo Technology WLI-TX4-G54HP setup guide Aoss Installation, Aoss button

AOSS Installation

If your Wireless Router/Access Point supports AOSS, then AOSS can configure your wireless network for you. To use AOSS to connect your Ethernet converter to your wireless network:

•Confirm that the Wireless Router/Access Point and the Ethernet

Converter are both powered on.

•Hold down the AOSS button on the Wireless Router/Access Point for 3 seconds.

•Hold down the AOSS button on the Ethernet converter for 3 seconds.

AOSS will take about a minute to configure your wireless network. When finished, the AOSS LEDs on both the Wireless Router/Access Point and the Ethernet Converter will stop blinking and stay lit. You now have a secure connection!

AOSS button

NOTES: If AOSS is used, then any non-AOSS wireless client devices in your network will have to be manually re-configured to connect to the Router/Access Point in AOSS mode; please consult your Router/Access Point documentation for more information on adding non-AOSS devices.

AOSS configures your SSID, encryption type, wireless channel, and encryption key, and makes a secure connection between your wireless components. You may need to run your router's configuration utility to configure your internet connection before using AOSS.

If AOSS does not finish properly, power cycle both the Router/Access Point and the Ethernet Converter and attempt the AOSS process again. AOSS works best when the router and the Ethernet Converter are physically close. You can always move them further apart when configuration is complete.