Using the Remote Control
TUNER
CD | POWER | STATION |
TAPE | BAND | FREQ |
| FM | DIRECT |
TUNER | MONO | CLASS ACCESS |
| 1 | 2 | 3 |
|
| TEST | REAR | Receiver/ | |
| 4 | 5 | 6 | |
| TONE | LEVEL |
| |
| MODE | LEVEL | Amplifier | |
| CENTER | CENTER | Buttons | |
MODE | 7 | 8 | 9 | |
CONTROL |
| |||
| DELAY | DISC |
| |
SURROUND | TIME | EFFECT |
| |
| 0 |
|
|
|
| PRO LOGICDSP MODE | MUTING |
| |
| VIRTUAL | LOUD |
|
|
RECEIVER |
|
| MASTER |
|
POWER | FUNC | DIRECT | VOLUME |
|
AUDIO/VIDEO
REMOTE OSR
RECEIVER POWER
The remote control works up to a distance of about 23 feet, and within a 30- degree angle on either side of the receiver. Point the control at the receiver’s front panel and press the desired button(s).
Many buttons on the remote control work the same as buttons on the receiver’s front panel. Use these buttons exactly as you would use the corresponding but- tons on the receiver.
CONTROL MODE Buttons
The three CONTROL MODE buttons select the device you connected to the CON- TROL OUT jack of the
Receiver/Amplifier Operation
Before operation, press TUNER to select receiver/amplifier operation.
STATION | Tunes to the next higher or lower memory location. |
BAND | Selects the AM or FM tuner band. |
FREQ | Tunes to radio stations. |
FM MONO | Selects the FM reception mode. |
CLASS | Selects the memory class. |
DIRECT ACCESS | Allows direct input of the station frequency. |
Number Buttons | Select the corresponding memory station. During Direct Access, |
| enter the station’s frequency. |
TEST TONE | Sounds test tones from each speaker when pressed after SUR- |
| ROUND. |
–REAR LEVEL + Controls the sound level of the rear speakers when pressed after
SURROUND.
CENTER MODE | Selects among the three center modes or 3CH Logic when |
| pressed after SURROUND. |
–CENTER LEVEL + Controls the sound level of the center speaker when pressed af- ter SURROUND.
DELAY TIME | Sets the |
| Simulated Surround programs when pressed after SURROUND. |
– EFFECT+ | Adjusts the level of DSP or Dolby Virtual mode. |
PRO LOGIC | Selects Dolby Pro Logic Surround. |
DSP MODE | Selects the DSP mode; HALL, JAZZ, DANCE, THEATER 1, or |
| THEATER 2. |
MUTING | Silences the receiver. Press again to restore the sound to its pre- |
| vious level. |
VIRTUAL | Selects Dolby Virtual. |
LOUD | Turns the loudness feature on and off. |
FUNC | Selects a program source (VCR, PHONO, tuner, CD, or DVD/ |
| LD). Repeatedly press until the display shows the desired pro- |
| gram source. |
24