NOTE: Read the entire instruction manual before starting the installation.
SAFETY CONSIDERATIONS
Improper installation, adjustment, alteration, service, maintenance, or use can cause explosion, fire, electrical shock, or other conditions which may cause death, personal injury or property damage. Consult a qualified installer, service agency or your distributor or branch for information or assistance. The qualified installer or agency must use factory-authorized kits or accessories when modifying this product. Refer to the individual instructions packaged with the kits or accessories when installing.
Follow all safety codes. Wear safety glasses, protective clothing, and work gloves. Have a fire extinguisher available. Read these instructions thoroughly and follow all warnings and cautions included in literature and attached to the unit. Consult local building codes and the current edition of the National Electrical Code (NEC) NFPA 70.
In Canada, refer to the current editions of the Canadian Electrical Code CSA C22.1.
Recognize safety information. When you see this symbol 
on the unit and in instructions or manuals, be alert to the potential for personal injury. Understand the signal words DANGER, WARNING, and CAUTION. These words are used with the safety-alert symbol. DANGER identifies the most serious hazards, which will result in severe personal injury or death. WARNING signifies hazards, which could result in personal injury or death. CAUTION is used to identify unsafe practices, which may result in minor personal injury or product and property damage. NOTE is used to highlight suggestions which will result in enhanced installation, reliability, or operation.
INSTALLATION CONSIDERATIONS
The WiFi Broadband Wireless Remote Access Module (WiFi B-SAM), part number SYSTXBBRWF01, is powered with a 24VAC transformer which is included. A 120VAC supply must be near the mounting location. Provisions must be made to secure the transformer to the outlet. The D-wire (24VAC) from the
Evolutionr system must NOT be used to power the Remote Access Module.
This instruction covers the physical installation and start up of WiFi B-SAM. Use this instruction to guide the actual installation process after the Evolution system(s) have been installed. One WiFi B-SAM is capable of handling two Evolution systems.
INTRODUCTION
The WiFi B-SAM connects to a network router and allows remote connectivity for up to two Evolution systems within the same building. The Evolution system owner, as well as authorized dealer, can monitor and control the system via the Internet, as well as by telephone. The WiFi B-SAM communicates wirelessly through the homeowner’s cable or DSL Internet service. Broadband Internet service with a wireless network router is required. The WiFi B-SAM is not compatible with dial-up
Internet service. The WiFi B-SAM can also monitor a dry-contact sensor to provide a warning for the presence of water in the building, or some other use. If the sensor is active, the Evolution system will not be disabled or shut down.
Computer Requirements
The WiFi B-SAM uses a web-based application to control and monitor the Evolution System. This application will work with any graphic user interface PC operating system (Microsoft, Apple, Linux). The web-based application is optimized for use with Microsoft’s Internet Explorer version 6 and above. Other web browsers are compatible with some possible screen formatting issues.
WiFi INSTALLATION
BEFORE STARTING:
SSYSTXBBUID01-B or SYSTXBBUIZ01-B is required (version 14 software revision or higher).
S Retrieve your wireless network’s SSID (network name) and encryption type and key (if used).
To get the SSID, right-click on the wireless network connection icon in the lower right corner of the desktop on a Windows-based PC that is connected to the wireless network:
Wireless Networks 
A08408
From the pop-up menu, choose View Available Wireless Networks.
A08409
A window will open showing all of the wireless networks available:
