Section 2 - Driver Installation
This section contains instructions for installing the ESP driver from the Equinox SuperSerial
2.1 Windows 2000
To install the Windows 2000 ESP driver, you must first run SETUP.EXE from the Windows 2000 ESP driver diskette that is made using the Equinox SuperSerial
The Windows 2000 ESP driver is installed when you install the first ESP.
1.Navigate to Settings - Control Panel - Add/Remove New Hardware.
2.From the Add/Remove Hardware Wizard, select Add/troubleshoot a device.
3.Windows 2000 will search for new Plug and Play hardware on your computer. ESP devices are
4.From the Find New Hardware page, select No, I want to select the hardware from a list.
5.A list of hardware types will be displayed. Select
6.Windows 2000 will ask you to select a device driver. Highlight
Equinox Systems Inc., select Equinox Ethernet Serial Provider / Have Disk and point the Wizard to your A: drive.
7.From the Select a Device Driver page, again select Equinox Ethernet Serial Provider.
8.The Wizard will locate an ESP on your server’s local subnet and display information about that ESP. If your ESP does not yet have an IP address, you must enter the IP address, then click Next.
9.The Wizard will display the ESP conguration for nal verication. If the IP address you assigned is correct, click Next.
10.The Wizard will now copy les from the Windows 2000 ESP driver diskette. During this process, the Equinox ESP driver le is examined for a Microsoft digital signature. If the ESP driver is not signed, a warning message is displayed. To continue the installation, read the warning and then click Yes.
If you click No, the installation will terminate and the ESP will not be installed on your server.
9Equinox ESP