Chapter 2: Installation | 7 |
|
|
Setting up your network
The DSR switching system uses IP addresses to uniquely identify the switch and the target devices. The DSR1024 switch supports both Dynamic Host Configuration Protocol (DHCP) and static IP addressing. Avocent recommends that IP addresses be reserved for each switch and that they remain static while the DSR switches are connected to the network. For additional information on setting up the DSR switch using the DSView Server software, and for information on how the DSR switch uses TCP/IP, see the DSView Installer/User Guide.
Getting Started
Before installing your DSR1024 switch, refer to the following lists to ensure you have all items that shipped with the DSR1024 switch, as well as other items necessary for proper installation.
Supplied with the DSR1024 switch
•Power transformer
•Local country power cord
•Two ribbon cables with
•One
•One
•One CAT 5 patch cable for connecting the DSRIQ
•One DSRIQ module (either PS/2 or USB, depending on configuration purchased)
•DSR1024 Installer/User Guide (this manual)
•DSR1024 Quick Installation Guide
Additional items needed
•(Optional)
•One CAT 5 patch cable for network connectivity
•DSView software
•(Optional) V.34, V.90 or
•(Optional) SPC power control device