Avocent manual Rack Mounting Your SwitchView 1000 Switch

Page 9

Chapter 1: Installation

3

 

 

NOTE: PS/2 and USB interfaces cannot be used simultaneously.

USB KVM

Connection

PS/2 KVM

Connection

Power

User

SwitchView 1000 Switch

Server

Figure 1.2: Basic SwitchView 1000 Switch Configuration

CAUTION: To reduce the risk of electric shock or damage to your equipment:

-Plug the power cord into a grounded (earthed) outlet that is easily accessible at all times.

-Disconnect the power from the unit by unplugging the power cord from either the electrical outlet or the unit.

Rack Mounting Your SwitchView 1000 Switch

Your SwitchView 1000 switch may be rack mounted using brackets. Before installing the appliance, stabilize the rack in a permanent location. Install your equipment starting at the bottom of the rack, then work to the top.

CAUTION: Rack Loading - Overloading or uneven loading of racks may result in shelf or rack failure, causing damage to equipment and possible personal injury. Stabilize racks in a permanent location before loading begins. Mount components beginning at the bottom of the rack, then work to the top. Do not exceed your rack load rating.

Image 9
Contents SwitchView 1000 Switch Page SwitchView→ Power On Table of Contents Iv SwitchView 1000 Switch Installer/User Guide Installation Installation Rack Mounting Your SwitchView 1000 Switch ScrLk + ScrLk + Spacebar Accessing and using the OSD menusSetup Options Window Upgrading firmware To upgrade your SwitchView 1000 switchTo cascade multiple switches Daisy-chaining your SwitchView 1000 switchBasic Daisy-Chain Example Appendix a Quick Reference Guide Show OSD ScrLk + ScrLk + Appendices SwitchView 1000 Switch Installer/User Guide Page For Technical Support Avocent Corporation Corporate Drive