‰‰FR Features FR-8 not shown Front Panel, Rear Panel

Operating Manual - FR-8 and FR-16 Remote Level Controller

FR Features (FR-8 not shown)

Front Panel

1)Push Button LED Label Window - Insert switch label made from Ashly template doc

2)Push Button LED - Used to switch fader Mute or fader A/B Source Select. LED also indicates signal level or fader status

3)Channel Fader - Adjusts level of targeted DSP gain stage or output mixer source

4)Channel Fader Label Window - Insert switch label made from template doc

5)Power LED - Shows device is powered

6)Master Fader - Adjusts level of all assigned channel faders

Rear Panel

1)RJ-45 Jack - Connects to Ethernet Network with PoE or PoE injector

2)Link LED - Shows network is connected

3)Data LED - Shows Data is transferring

4)Lockout Connector - Used with contact closure to disable all front panel controls

5)Serial Number and MAC Address - Used for warranty or flash programming

On Startup:

1.When the FR-8 or FR-16 is first connected or powered on, it attempts to communicate with all devices it has been programmed to control, if any.

2.Once communication with the targeted device is established, it waits to transmit any fader or switch position data until a control is physically changed by the user. At that point only the data for that control is sent.

***This feature prevents sudden and unexpected changes when reconnecting or re-starting the FR remote control, as well as when a new preset is recalled to the host device.

PLEASE NOTE: When in doubt, make sure all faders are either in the correct position or fully down before reconnecting