American Audio SCD-100 manual Setting CUE Points, Creating and Playing a Loop

BASIC OPERATION

13. SETTING CUE POINTS

A cue point is the exact point playback will begin when the PLAY/PAUSE BUTTON (18) is pressed. A cue point may be created anywhere on a disc or in a track.

Use the JOG WHEEL (13) to set a cue point by frame. While the disc is in pause or cue mode, use the JOG WHEEL (13) to scroll through a track to find your desired starting point. Once you have found your desired cue point press the PLAY BUTTON (18) to enter this point in to the unit's memory. At this point when ever the CUE BUTTON (16) is pressed it will return the track to this exact point.

TRACK M S F

Figure 28

14.CREATING AND PLAYING A LOOP

A loop is a sound loop that plays continuously. You can use this loop to create effect in your mixing. This loop has no time limit and you could actually loop the entire length of disc. You create a loop between two continu- ous points of a disc. The following steps illustrate the procedures for creating a loop:

1)Press the PLAY/PAUSE BUTTON (18) to activate playback mode.

TRACK M S F

Figure 28

TRACK M S F

2) Press the LOOP BUTTON (9) . This will set the starting loop point. The LOOP LED (8) will flash briefly indicating a starting point has been set.

3)Press the LOOP BUTTON (9) again to set the ending point

for your LOOP (Figure 13). The LOOP LED (8) will begin to flash indicating a loop has been activated.

Figure 28

TRACK M S F

EXITING A LOOP - To exit a loop, press the LOOP BUT-

TON (9) . Music playback will resume normal play.

Figure 28

©American Audio® - www.americandj.com - SCD-100™ Instruction Manual Page 18