1 | Desktop CPEi 725 User Guide |
Front of the CPE
The front of the CPE unit contains LED Link/Activity indicators. The LEDs provide the status of the unit and signal strength indicators for easy adjustment during setup.
Table
LED | Status |
Signal Strength | Full WiMAX Signal Strength is detected |
| when all WiMAX Signal Strength LEDs are |
| lit. |
| • All WiMAX Signal Strength LEDs are |
| off - very low signal detected. |
| • One to two WiMAX Signal Strength |
| LEDs are lit - low signal detected. |
| • Three to five WiMAX Signal Strength |
| LEDs are lit - high signal detected. |
|
|
WAN WiMAX | While acquiring access to the WiMAX |
| Network: |
| • All WiMAX Signal Strength LEDs vary |
| between ON, OFF and/or BLINKING |
| status. |
|
|
CAUTION
If all five WiMAX Signal Strength LEDs are blinking, then a software up- grade is in progress. Do NOT remove power to the CPE.
Back of the CPE
The back of the CPE unit contains the reset switch, AC Power Connector, Ethernet
68P09308A83 | |
| DEC 2009 |