Dynacord DPA 4410 dimensions Incorporation Into 19 Flightcases or 19 Rack Systems, Fuses

T101	T104
INPUT 1	INPUT 4
T102	T103
INPUT 2	INPUT 3

TO AMP_A	TO REMOTE CONTROL	TO AMP_B
PCB 84167	PCB 81330.2	PCB 84167

Diagram 9 Printed circuit board 81330.1 with inserted input transformers NRS90208

10.INCORPORATION INTO 19" FLIGHTCASES OR 19" RACK SYSTEMS

Note Do not operate the DPA 4410 without its enclosure or without parts of the enclosure.

When incorporating the DPA 4410 into a 19" flightcase or 19" rack system make sure, that there is sufficient air-flow. Between the amplifier’s rear plate and the back-wall of the surrounding enclosure there has to be at least a space of 60 mm x 330 mm up to the enclosures ventilation gaps. Above the rack system should be at least a space of 100 mm for a sufficient circulation of the air. During the operation of the DPA 4410 the environmental temperature within the rack closet may increase by about 10° C. This has to be taken into consideration when installing other equipment into the same rack system or other enclosures.

Note For trouble-free operation of the appliance, the maximum environmental temperature should not exceed +40° C.

11. FUSES

location	pos.	used for	value	dimensions	standard
fuse switch (11)	F501	mains fuse 230V~ AC	T4A 250V	5 x 20 mm	IEC 127
fuse switch (11)	F501	mains fuse 115V~ AC	T8A 250V	5 x 20 mm	IEC 127
PCB 85264.2	F502	battery fuse 24V DC	25A 32V	flat-type fuse	DIN 72581-3
PCB 85264.2	F503	battery fuse 24V DC	25A 32V	flat-type fuse	DIN 72581-3
PCB 85264.2	F504	power-AMP 1	T6.3A 250V	5 x 20 mm	IEC 127
PCB 85264.2	F505	power-AMP 2	T6.3A 250V	5 x 20 mm	IEC 127
PCB 85264.2	F506	power-AMP 3	T6.3A 250V	5 x 20 mm	IEC 127
PCB 85264.2	F507	power-AMP 4	T6.3A 250V	5 x 20 mm	IEC 127

28