DPA 4410 Power Amplifier, Features | Dynacord instruction

OWNER’S MANUAL

DPA 4410 POWER AMPLIFIER

∙4 x 100 W output capacity

∙off ground potential 100 V outputs (internally configurable to 70 V/50 V or 4 ohms)

∙all outputs are protected against floating (no load) and short-circuit

∙mains supply 115/230 V AC or battery operation 24 V DC

∙mains switch 115/230 V

∙REMOTE CONTROL start with STANDBY indicator (mains and battery operation)

∙service mains switch

∙GROUND-LIFT switch

∙active ventilated through a temperature-controlled DC ventilator

∙electronically balanced inputs

∙routing switch for parallel operation of the amplifier inputs

∙input level control

∙power-on noise suppression

∙3 LED indicators with CLIPPING indicator for metering purposes

∙MONITOR outputs

∙temperature control with PROTECT indicator

∙fault indicators: READY and GROUND FAULT

∙fault message via off potential READY contact

∙TEST switch for pilot tone surveillance and GROUND FAULT reset

∙off ground potential, balanced input transformer are optionally available

∙pilot tone surveillance module and ground fault surveillance module are optionally available

∙19" rack dimensions with 3 HU