Enfora GSM0000PB001MAN Connecting the GSM/GPRS Antenna, GSM/GPRS Spider SA Connecting the Antenna

Page 14

GSM/GPRS Spider SA User Manual

3.4Connecting the GSM/GPRS Antenna

The antenna is supplied by the user. The antenna must have a nominal impedance of 50 Ohms. The VSWR must be less than 2.0:1. System antenna gain should be 0-2 dB for optimum performance. See section 2 Regulatory Compliance FCC.

There are two varieties of GSM/GPRS Spider SA modems. Model number GSM1202 operates at the 900/1800 MHz frequency band while model number GSM1203 operates in 1900 MHz frequency band. Care needs to be taken when connecting the antenna since the right type of antenna will be required for proper operation of the modem. The antenna connector on the GSM/GPRS Spider SA modem is SMA Female. The antenna has to be connected to the connector labeled “Antenna” as shown below in Figure 7.

Figure 7: GSM/GPRS Spider SA Connecting the Antenna

GSM0000PB001MAN

8

Version 1.07 - 02/14/05

Image 14
Contents Enfora GSM/GPRS GSM0000PB001MAN Limited Warranty Enfora L.P -MONTH Limited WarrantyIii Version 1.07 02/14/05 Revision History Release Date Description of Changes Number Figures Introduction About the GSM/GPRS Spider SA About this ManualSystem Requirements Spider SA Front and Back ViewRegulatory Compliance FCC DisclaimerInstallation Subscriber Identity Module SIM Card Inserting a SIM Card in a GSM/GPRS Spider SA ModuleConnecting the Power Supply Connecting The Power Supply To Spider SAGSM Operating Power Gprs Operating PowerConnecting the Serial Cable Connecting the Serial Cable to Spider SAConnecting the GSM/GPRS Antenna GSM/GPRS Spider SA Connecting the AntennaAttaching a Microphone/Speaker Attaching a Headset to the GSM/GPRS Spider SA ModuleUsing the GSM/GPRS Spider SA Modem I/O Interface Wago I/O Connector AttachmentGpio Pin Configuration SA Gpio Characteristics LED FunctionsMounting the GSM/GPRS Spider SA GSM/GPRS Spider SA Mounting Bracket attachedGSM/GPRS Spider SA Mounting Bracket separated GSM/GPRS Spider SA Mounting Bracket ready to mount Frequently Asked Questions FAQ How do I configure a PPP connection for PocketPC 2002? Tech Support