ATDI Command (place V.110 call)
Compression: None
Connected Standard: V.110
TX,RX Symbol Rate: 0, 0
TX,RX Carrier Frequency: 0, 0
TX,RX Trellis Coding: (n/a), (n/a)
Frequency Offset: 0 Hz
Round Trip Delay: 2 msecs
TX,RX Bit Rate: 9600, 9600
Robbed Bit Signalling (RBS) pattern: 0
Digital Pad: (n/a), Digital Pad Compensation: None 10:37:20:Dynamic event:
Sq Value: 7
Signal Noise Ratio: 0 dB
Receive Level: 0 dBm
Phase Jitter Frequency: 0 Hz
Phase Jitter Level: 0 degrees
Far End Echo Level: 0 dBm
Phase Roll: 0 degrees
Total Retrains: 0
EC Retransmission Count: 0
Characters transmitted, received: 0, 0
Characters received BAD: 0
PPP/SLIP packets transmitted, received: 0, 0
PPP/SLIP packets received (BAD/ABORTED): 0
EC packets transmitted, received OK: 0, 0
EC packets (Received BAD/ABORTED): 0
V110 frames received bad: 0
V110 frames received good: 26
V110 frames transmitted: 33
V110 sync lost: 0
...
...
...
1d06h :End Connect event: Call Timer: 105 secs Disconnect Reason Info: (0xDF06)
Type (=6 ): Tx (host to line) data flushing - OK Class (=31): Requested by host
Reason (=6 ): network indicated disconnect Total Retrains: 0
EC Retransmission Count: 0
Characters transmitted, received: 247, 307
Characters received BAD: 0
PPP/SLIP packets transmitted, received: 9, 9
PPP/SLIP packets received (BAD/ABORTED): 0
EC packets transmitted, received OK: 0, 0
EC packets (Received BAD/ABORTED): 0
V110 frames received bad: 3
V110 frames received good: 20758
V110 frames transmitted: 20995
V110 sync lost: 1
ATDI Command (place V.110 call)
The calling user can manually communicate with a V.110 modem in order to originate a remote V.110 dialout from the called modem. The AT command set now includes the ATDI command (place V.110 call) to allow a V.110 call to be originated from the called modem. The user enters the ATDI command after establishing a session with the MICA modem in order to
Basic V110 for MICA Modems on Cisco Access Servers 9