Actiontec electronic 56K/V.92 user manual Installing the Software

Page 24

Chapter 3 Installing the Software

16.A “Modem Setup” window appears, stating that the computer needs to be restarted before the Modem can be used. Click OK.

17.After the computer has restarted, an “Install New Modem” window appears, stating that the Modem has been set up successfully. Click Finish.

The Modem is now ready to use. To use the Modem to dial into a Windows NT Remote Access server or connect to the Internet, configure “Dial Up Networking.” For more details, see the Windows NT documentation.

21

Image 24

Contents External Modem Table of Contents Page Features Introduction1Package Contents Firmware UpdatesSafety Information Connecting the ModemShock Hazard Technical Support Actiontec Electronics, IncConnecting Modem Serial CablePower Switch Front PanelLEDs Installing Software Windows 98 and 98 SEPage Installing the Software Windows Me Installing the Software Page Verifying Driver Software Installation Windows 98 and Me Page Windows NT Next window, click Have Disk… Installing the Software Page Installing the Software Page Installing the Software Windows Installing the Software Page Windows XP Page Verifying Driver Software Installation Windows 2000 and XP Page Troubleshooting When I restart my computer, the Modem is not detectedPage AT Commands Command FormatBasic AT Commands ITU-T V.90 Operation Commands Dial Line Rate S3756K Dial Line Rate S38 Command Examples K56flex and V.90 Selection S109Regulatory Compliance Notices Class B EquipmentModifications Limited Warranty Return the product to In the United States Limited Warranty