Chapter 1 Introduction
Safety Information
Shock Hazard
To avoid shock hazard:
The power cord and any other equipment to which this product is attached must be connected to properly wired receptacles. Do not connect or dis- connect any cables or perform installation, maintenance, or reconfiguration of this product during an electrical storm.
When using telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and injury. Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. Use caution when installing or modifying telephone lines. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electrical shock from lightning. Do not use the telephone to report a gas leak in the vicinity of the leak.
Connecting the Modem
Do not connect the Modem to a digital PBX (switchboard) system, as dam- age to the Modem can occur. Modems are designed to function with analog telephone lines, such as residential lines.
Do not connect the Modem to an ISDN line. In some areas, ISDN (digital) lines are provided for residences and businesses. These lines may damage the Modem.
☞Note: The Modem is fully compatible with analog telephone lines connected to a Digital Exchange. Digital Exchanges are used in some areas to supply analog lines to homes and businesses.
3