Navini Networks Ripwave manual Care and Maintenance, Charging

Navini Networks, Inc. Ripwave MX Modem User Guide

Charging the

HD-EBP

The HD-EBP needs to be recharged when the battery is connected to a Modem and the Modem is turned on but the LED on the back of the battery remains off (indicating the battery has no power) or is red (indicating the battery level is low).

To recharge the battery pack, use only the 12V charger that came with the HD-EBP. Using any other charger can damage the battery. To charge the HD-EBP, plug the 12V adapter into the 12V input socket on the HD-EBP. Plug the other end of the adapter into an electrical wall socket.

Care and Maintenance

Pig-tail Cord

Plugs into

Wall Socket

12V Input Socket

Note: Do not attempt to plug the 12V adapter into the Modem as this may harm the Modem.

Note: The battery may charge while it is connected to a Modem.

Your Modem is designed to give you years of trouble-free service. To ensure operation, read the following care and maintenance instructions.

Keep the Modem free of dust and moisture. If the Modem gets wet, use a towel to dry it immediately.

Handle the Modem gently. Dropping it or mishandling it can cause damage to the plastic shell or the electronic circuitry.

Keep the Modem away from high temperatures. Heat can cause damage to the plastic shell or the electronic circuitry.

30

060210_pv1.6_Ripwave-MX Modem User Guide_40-00382-00b(4.4.2)