IPsec User Guide
4.Configure the IPSec Interface parameter as “1”, to enable IPSec. Once IPSec is enabled, the factory default settings should be restored. Table 2‐1 lists all the IPSec parameter default values. The required fields for IPSec to be estab‐ lished are:
a.IPSec Gateway
b.
c.IKE Encryption Algorithm
d.IKE Authorization Algorithm
e.IKE Key Group
f.IKE SA Life Time
g.Remote Address
h.IPSec Encryption Algorithm
i.IPSec Authentication Algorithm
j.IPSec Key Group
k.IPSec SA Life Time
l.Incoming Out of Band: If you want mobile termination
m.Outgoing Host Out of Band: To access internet outside the tunnel, from the modem.
5.Make sure the static IP address of PC2 is on the same subnet as the modem’s host private IP. PC1 picks up the dynamic IP address and PC2 should be set to a static IP address.
6.Click on Reset, to reset the modem.
The IPSec tunnel is set up.
Now you should be able to reach the other side of the server from PC1 an/or PC2. Both the machines (PC1 and PC2)can be communicated with, from the server through the IPSec tunnel. The modem should be reachable from the remote server as well.
|
|
|
|
|
|
|
17 |
|
|
|
|
| 2120028 |
|
|
|