Switching the appliance into the Fwd mode:
•Place the switch 1 for continuous shredding at the position "Fwd" (forward). The appliance runs continuously. Insert paper from above and in portrait format into the cutter opening 2.
Switching the appliance into the Auto mode:
•Place the switch 1 for shredding into the position "Auto". The motor starts automatically and switches itself off automatically if no further paper is in- serted.
Take note: Always guide smaller papers into the middle of the cutter opening 2. The contact which starts the cutting process is located there.
Clearing a material blockage:
•Slide the switch 1 into the position "Rev" (Re- verse = reverse) should the paper to be shred- ded jam.
The appliance now goes into reverse and the paper to be shredded is returned.
•Pull the paper to be shredded out of the appliance and then place the switch 1 at "Auto".
•The appliance is now once again ready for ope- ration.
Switching the appliance off:
•When you no longer need the appliance, always remove the plug from the mains power socket.
Notice regarding overheating of the appliance: If it overheats, the appliance switches off automati- cally.
Warning:
Remove the plug from the mains power socket to avoid an unintended starting of the appliance.
•Empty the container.
•Allow the appliance to cool down.
•
•Switch the appliance on, in that the switch 1 is placed into the position "Auto".
Cleaning
Danger!
Always remove the power plug before cleaning the appliance. There is a risk of receiving an electric shock!
Warning!
The cutters in the appliance are very sharp! Injury hazard!
•Remove any remnants that may be present in the cutter opening 2 or the cutter blades with a suita- ble object, such as a pair of tweezers. Ensure that the plug has been disconnected.
•Clean the appliance with a lightly moistened cloth. For stubborn soiling use a mild detergent on the cloth.
Non-functionality
If the material to be shredded jams:
This means that you have inserted too much paper into the appliance (max. 5 Sheets 80g/m2).
•Slide the switch 1 into the position "Rev" should the paper to be shredded jam. The appliance now goes into reverse and the material to be shredded is returned.
•Pull the paper to be shredded out of the appliance and then place the switch 1 at "Auto".
•The appliance is now once again ready for operation.
If the appliance suddenly ceases operation: This means that the appliance is overheated and the automatic safety
- 4 -