Fellowes 4250C, 4250S KEY Capabilities, Basic SET UP Basic Shredding Operation, Paper shred size

G.

A.

ENGLISH

Models 4250C/4250S

KEY

B. H.

C.

D.

E.

F.

CAPABILITIES

A. Safety Shield B. Paper entry

C. Disconnect switch (open door)

D.Door

E.Basket (inside)

F.Casters

G.See safety instructions

H. Control Panel and LEDs 1. ON/OFF (blue)

R2. Reverse (red)

3. Bin full (yellow)

4. Door open (red)

5. Safety Shield Open (red)

Will shred: Paper, credit cards, CD/DVDs, staples, paper clips and junk mail

Will not shred: Adhesive labels, transparencies, newspaper, cardboard, laminates, file folders, X-rays or plastic other than noted above

Paper shred size:
Strip-Cut	5/32 in. (4mm)
Cross-Cut	5/32 in. x 1-9/16 in. (4mm x 40mm)

Maximum:
Paper entry width	12-1/5”(310mm)

8.5”x11”, 20lb., (75g) paper at 120V, 60 Hz, 8Amps; heavier paper, humidity or other than rated voltage may reduce capacity.

*In order to perform at capacity, shredder must be plugged into a dedicated 15Amp, 120V outlet.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

•Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders.

•Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use.

•Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.

•Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder.

•Do not use if damaged or defective. Do not disassemble shredder. Do not place near or over heat source or water.

•Do not operate the machine without the safety shield closed (A)

•This shredder has a Disconnect Power Switch in the cabinet door. The door must be fully closed to operate shredder. In case of emergency, open cabinet door. This action will stop shredding immediately.

•Avoid touching exposed cutting blades under shredder head.

•Do not put foreign objects in paper entry.

•Shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with

this product.

•FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.

•For indoor use only.

•Unplug shredder before cleaning or servicing.

BASIC SET UP BASIC SHREDDING OPERATION

SHREDDER SET-UP
1	2	3	4

Open the door	Place cutter head into	Ensure access to a	Make sure safety flap
	top of cabinet, use 2	dedicated 15Amp,	is securely in place
	people	120V outlet

TO SHRED

1	2	3	4	5
				or
	R		R
Plug in and make	Press ( ) ON to	Feed paper straight	When finished	Do nothing and shredder
sure door is closed	activate	into paper entry and	shredding set to	will automatically shut
		release	( ) OFF	off after 30 minutes of
				inactivity