Maintenance
Regular emptying of the baske t is important to ensure the smooth operation of the cutting cylinders. If you can see paper in the basket window (7), turn off the shredder, pull out basket and empty basket contents.
Regular oiling of the
•Apply oil over full width of paper entry (7) with shredder in off [O] position.
•Press control switch to automatic [I] position which will cause shredder to run for about 2 seconds.
•Press and hold control switch in reverse [R] position for
•Repeat above automatic [I] and reverse [R] sequence three times.
R E M I N D E R : Do not use flammable synthetic oil,
Troubleshooting
If you have a problem with your shredder, check the symptoms and remedies below. If you cannot solve the problem this way, contact Fellowes Customer Service. Do not open shredder head to attempt repair: It could expose you to serious electric shock and will void your warranty.
S y m p t o m
Shredder does not start or stops while shredding.
Red display light (9) turns on and shred- der will not operate.
Shredder squeaks, grinds or runs below capacity.
Shredder continues to run for a few sec- onds after paper has cleared the cutting cylinders.
Re m e d y
•Make sure shredder is plugged in and switch is in automatic [I] position.
•If paper appears to be jammed, fol- low instructions under Operation.
•Check basket position; basket must be pushed all the way in the cabinet. Follow instructions under S e t- U p.
•Wait 20 minutes for shredder to cool down before trying again.
•If paper appears to be jammed, fol- low instructions under Operation.
•Check basket position; basket must be pushed all the way into the cabinet. Follow instructions under S e t- U p.
•Oil cutting cylinders (OD1200C only). Follow instructions under
M a i n t e n a n c e.
•Check window. If paper is visible, empty basket. Follow instructions underMaintenance.
No action required. This is a
5