Fellowes 120-2, 120C-2 manual Maintenance, To empty waste basket, To clear a paper jam

Page 6

To empty waste basket

If basket full light (I) is on, follow these steps until light turns off.

1• Press manual forward button (G) to finish shredding any paper in paper entry.

Press control switch (E) to the off [O] position.

Open the waste basket drawer (A) and remove full bag.

Place new bag in basket, then slide drawer into cabinet.

2• Press and hold control switch (E) in the reverse [R] position for a few seconds to clear paper shreds that have collected under cutting cylinders.

Alternate between manual forward (G) and reverse [R] for a few seconds in each position.

CAUTION: The shredder may be damaged if you alternate too rapidly between forward and reverse.

3• Unplug shredder and remove wastebasket drawer (A).

Carefully clear any paper shreds that have collected on under side of paper entry (C). CAUTION: Model 120C-2 (confetti cut model) has exposed blades.Use care when removing paper shreds on underside of paper entry.

To clear a paper jam

If paper jam light (J) is on, follow these steps until light turns off.

Check the waste basket and empty if full.

Press and hold control switch (E) in the reverse [R] position to back paper out of paper entry (C). Try pulling gently on paper to remove it from shredder.

Alternate between forward and reverse, if needed:

Press and hold manual forward button (G) for a few seconds.

Press and hold control switch (E) in the reverse [R] position for a few seconds.

Continue alternating between forward and reverse until the jam clears.

CAUTION: The shredder may be damaged if you alternate too rapidly between forward and reverse.

Maintenance

Empty waste basket regularly to ensure the smooth functioning of the cutting cylin- ders. The shredder will not operate when the basket is full.

Oil confetti-cut model (120C-2) regularly to ensure proper operation.

If used at or near daily capacity, apply oil every time you empty the basket. Use Fellowes Powershred Lubricant #35250 or other non-aerosol vegetable- based oil in a long-nozzle container (sample oil provided).

CAUTION: Do not use flammable synthetic oil, petroleum-based products, or aerosol lubricants of any kind.

To oil the cutting cylinders

Apply oil over full width of cutting cylinders through the paper entry (C).

Press and hold the manual forward button (G) for at least 3 seconds.

Press and hold the control switch (E) in reverse [R] for at least 3 seconds.

Repeat the forward/reverse sequence 3 or more times.

English

5

Image 6
Contents Get More Done Today Page Contents Product Profile While setting up shredderWhen not in use While operating shredderSet-Up Control SwitchesTroubleshooting Lights OperationTo clear a paper jam MaintenanceTo empty waste basket To oil the cutting cylindersSupplies TroubleshootingSymptom Remedy Quantity Part NumberLimited Warranty 00 800 1810 Accessible via most major telephone networksAll European Countries