Shredder doesn’t start | Fellowes 3011001 guide

OPERATION

Continuous operation:

5 minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 4-5 minutes will trigger

20-minute cool down period.

Set to Off

PAPER

Press Auto-On ( )	Feed into paper entry
	and release

CARD

Press Auto-On ( )	Hold credit card	Feed into card entry
	at edge	and release

Set to Off

TROUBLESHOOTING

Paper jam: Set to Off and empty basket. Replace basket and follow any or all of the below procedures.

Press and hold	Alternate slowly back and forth	Set to Off	Pull uncut paper from	Press and hold
Reverse (R)			paper entry	Reverse (R)

Shredder doesn’t start:

Yellow - SafeSense® active

Yellow flashing - SafeSense® not active

Make sure control switch is in Auto-On () position

Clear paper particles covering magnetic safety interlock

Wait 20 minutes for red light to turn off

ATTENTION: If the SafeSense® light remains on, you must engage the Override Switch in order to perform steps above. Once the jam is cleared, reset the SafeSense® feature. (See SafeSense® instructions below.)

SafeSense® paper jam: If the SafeSense® feature activates (SafeSense® light remains on) to cause the user to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense® feature and clear the paper. Warning – when switch is in override position, the SafeSense® light will flash and the SafeSense® feature will NOT function. Once the paper is cleared, reset the SafeSense® feature.

Sensor light illuminated–paper jammed

SafeSense® override switch

MAINTENANCE

Run regularly in reverse for one minute

Oil when bin is full, or immediately, if:

•Capacity decreases

•Motor sounds different, or Shredder stops running

Active

Not active

Follow oiling procedure below and repeat twice.

Set to Off	*Apply oil	Press Auto-On ( )	Shred one sheet	Press and hold
	across entry			Reverse (R)
	*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250/3505006			2-3 seconds

WARRANTY

LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original consumer. Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part.

This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE,

IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product.

This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law.

For more details or to obtain service under this warranty, please contact us or your dealer.