|
| FA 500.2 |
|
|
|
|
|
Safety switch on the inspection door (only | Shredding material |
| |
stand |
|
|
|
Open the inspection door.
The shredder must switch off immediately and the ”Safety circuit interrupted” LED must light up.
The machine will only start again once you have closed the inspection door.
Safety switch on the protective flap (only stand
•Press the green start button.
` The cutting block and feed belt start up.
•Place the material to be shredded on the loading tray and then place batches on the feed belt.
If material that is not supposed to be shred- ded is mistakenly placed onto the belt, never attempt to pull it out
•Press the stop button.
`The drive stops.
•Press the reverse button.
`The cutting block and feed belt run in reverse.
•You can now remove the material from the belt and start the shredder again by press- ing the start button.
Open the protective flap.
The shredder must switch off immediately and the ”Safety circuit interrupted” LED must light up.
The machine will only start again once the protective flap is in its basic (vertical) position.
Stopping the shredder
•Press the stop button.
`The cutting block and feed belt stop.
`The shredder switches to standby mode.
Switching off the shredder
•Turn the main switch on the paper shred- der or the baling press to 0.
You can secure the main switch in this position using a padlock.
0702 | 9 |