Installation, Putting into operation, Scope of delivery

HSM 225.2	Paper shredder

Maintenance and service work may be performed only by:

• HSM customer service

• specially trained staff (e.g. qualiﬁ ed electricians)

•service technicians from our contracting partners

4.Installation

•This paper shredder should never be placed near or over a radiator or heat source.

•The ventilation slots must not be blocked or covered and they must be at a distance of at least 10 cm away from walls or furni- ture.

•Make sure the mains plug is easily acces- sible.

•Before plugging in the mains plug, check that the voltage and frequency of your local mains supply correspond to those stated on the type plate.

Before start-up:

Undo the wing screws securing the unit du- ring transportation.

1 • Press rocker switch pos. 1.

•Rocker switch locks in.

•Green LED lights.

• Paper shredder is ready for ope- ration (standby).

See „Technical data“ for sheet capacity.

• The shredding process is started by a photo–cell in the paper feeding opening.

• When the paper feeding opening is free again, the cutting sy- stem automatically switches off after approx. 3 sec. and returns to standby.

Feed CDs and disks through the slot in the safe- ty element. This protects you from splinters.

•Paper shredder, ready for connection, in carton packing

•5 Bags for shredded material

•Special cutting block oil 50 ml (cross cut)

•Operating instructions

Accessories:

•Bag for shredded material, order No.: 1.410.995.000

•Special cutting block oil 250 ml, order No.: 1.235.997.401

Switching paper shredder off

• Tap rocker switch pos. 2.

• Rocker switch resets to zero

position.

0510