Sony SFM1 installation manual Securing the Flat Panel to the Wall Mount, Lateral Shift Adjustment

SFM1

Securing the Flat Panel to the Wall Mount

WARNING: At least (2) qualified personnel are strongly recommended for installation of this product. Failure to do so could result in serious injury and possible damage to the flat panel.

1.Raise the flat panel with the LEFT and RIGHT mounting brackets secured to the flat panel and insert the top hooks from each bracket to the rod on the wall plate (Figure 13).

Wall Plate

TOP

BOTTOM

Figure 13. Securing The Flat Panel

Lateral Shift Adjustment

1.Make any lateral shift adjustment and lock it by tightening the two (2) ¼”-20 Phillips screws found on the bottom of the mounting brackets (Figure 14).

2.Use the foot leveler to adjust your plasma.

CAUTION: Do not over tighten the ¼”-20 screws to the rods.

Lateral Shift

Leveling Foot

¼ - 20” Screw

Figure 14. Lateral Shift Adjustment

Installation Manual Page - 13 -