SFM1
Griplates™
1.The Griplates™ have M4, M5, M6 and M8 hole patterns to fit the hardware that the flat panel requires. Example: If your display uses M8 x 20 Phillips head screws. Use the M8 mounting points (Figure 5).
Dimples | M8 |
|
|
M6
M5
M4
Figure 5. Griplates™ Orientation
2.Once the mounting brackets are aligned, secure the Griplate™ to the flat panel.
NOTE: The dimples of the top plates have to be facing up and the bottom dimples must be facing down. Use
(1)Griplate™ per mounting point (Figure 6).
CAUTION: Do not over tighten the mounting hardware.
Phillips Screw
Driver
DIMPLES
FACING UP
DIMPLES
FACING UP
DIMPLES
FACING DOWN
Bottom Flat Panel
DIMPLES
FACING DOWN
3/4"
Figure 6. Griplate™ Attachment
Page - 8 - | Installation Manual |