Sony MRW-EA7 manual Usage Notes, Other Points to Note Media formatting, Restrictions on DOS mode

Page 15

Usage Notes

“Memory Stick” Media

Notes on using “Memory Stick” media

Terminal

Write- Protected switch

Label area

Do not remove “Memory Stick” media while data is being read or written.

Data may be damaged if:

You remove “Memory Stick” media or disconnect the USB cable while data is being read or written.

You use “Memory Stick” media in a place where it is susceptible to static electricity or electric noise.

We recommend that you make a backup copy of important data in “Memory Stick” media.

Do not touch the terminal of “Memory Stick” media with anything including your fingers or metalic objects.

Do not bent, drop or put a big impact on “Memory Stick” media.

Do not disassemble or modify “Memory Stick” media.

Keep “Memory Stick” media away from water.

Do not use or keep “Memory Stick” media under an unfavorable condition as below:

Extremely hot place (such as in a parked car with windows closed in summer, a spot under direct sunlight, or near an electrical appliance that radiates heat).

Humid place.

Place near corrosive substances.

If you set Write-Protected switch “LOCK,” data cannot be recorded, edited, or erased.

Do not stick anything other than the supplied labels on the label area of “Memory Stick” media.

Stick a label precisely within the label area. Make sure that the label does not go beyond the area.

Notes on using “Memory Stick Duo” media

Terminal

Write-

 

Protected

 

switch

Memo area

 

When you use “Memory Stick Duo” media without Write-Protected switch, be careful not to edit or erase important data by mistake.

When you use “Memory Stick Duo” media with Write-Protected switch, data cannot be recorded, edited, or erased by “LOCK” the switch.

Use an object with a sharp tip to move the Write-Protected switch.

Do not press on the memo area strongly when writing.

Other Points to Note

Media formatting

Do not format (initialize) memory cards with a computer. If you format a memory card with a computer, devices such as digital cameras and mobile phone may not be able to use it due to differences in format type (FAT size, cluster size, hard disk type, or super floppy disk type). If you use a digital camera, format memory cards with your camera, instead.

Restrictions on DOS mode

In Windows, the reader/ writer does not operate in DOS mode.

To use the reader/writer, start up Windows.

15

Image 15
Contents Multi-Card Reader/Writer Trademarks Safety regulationsTable of contents Package Contents OverviewSystem Requirements Other memory cards Supported MediaMemory Stick media SD memory cardsFront Parts and FunctionsStart the computer Connecting the Reader/Writer to a ComputerInserting a Memory Card Using the Reader/ WriterReading and Writing Data on a Memory Card Open My ComputerInsert a memory card into the corresponding slot Removing a Memory Card Reader/writer Access indicator Status Reading the Access IndicatorDisconnecting Reader/Writer From Computer Pull the USB Cable out from computer About the size of Memory Stick What is Memory Stick?About Memory Stick media On formatting initializationRestrictions on DOS mode Usage NotesOther Points to Note Media formatting Operating and storage environments StandbyProblem Solution TroubleshootingTechnical Support SpecificationsImportant Notice End User License Agreement