Cisco Systems MCS 7845, MCS 7835, MCS 7825 manual

Page 11

Chapter 4 Installing Cisco Unified MeetingPlace Express Release 1.1.2

How to Install Cisco Unified MeetingPlace Express

Step 9 The Review New Network Settings page appears and displays all the network values you entered in Step 2 of the “Configuring the Cisco Unified MeetingPlace Express Server” section on page 4-8. Review these values to ensure they are correct. If they are correct, click Next.

If they are not correct, click Previous to go back to the previous pages and make changes.

If they are correct, click Next.

Note Changing the values on this page overwrites the values you entered earlier.

Step 10 The Configure NIC Settings page appears.

If your system uses Auto Negotiation, click On. The system automatically takes you to Step 12.

If your system does not use Auto Negotiation, click Off and proceed to Step 11.

Note Changing the values on this page overwrites the values you entered earlier.

Step 11 If your system does not use auto-negotiation, you must set the Speed (Full Duplex) and Duplex mode values. Select a speed and duplex mode for your system. Click Next.

Note Changing the values on this page overwrites the values you entered earlier.

Note Review these network setting values carefully. If you need to change them after the installation is complete, you must use the net command. See the “Running Application CLI Commands” section on page 9-6for more information about using the net command.

Step 12 The Cisco Unified MeetingPlace Express installer prompts you to create a Password for the user called root. The password must be at least eight characters and can contain any printable ASCII characters. The password is case-sensitive. Enter a password and then confirm the password. Click Next.

Step 13 The Cisco Unified MeetingPlace Express installer prompts you to create a Password for the user called mpxadmin. The password must be at least eight characters and can contain any printable ASCII characters. The password is case-sensitive. Enter a password and then confirm the password. Click Next.

Step 14 Review the pre-installation summary. Values include the product name, install folder, and the amount of disk space required and available for the installation target. If all the values are correct, click Install.

The Cisco Unified MeetingPlace Express installer installs the Cisco Unified MeetingPlace Express application. This can take between seven and 25 minutes.

When the installation is complete, the Cisco Unified MeetingPlace Express installer displays the Install Complete page.

Note If the Install Complete page displays a message stating that there were errors during the installation, uninstall the application, reboot the computer, and install everything again. If you still get errors after installing the operating system and application the second time, go to the log to see the error messages. The log is located at MPX_<version number>_InstallLog.log.

Step 15 Click Done to finish the installation. The DVD-ROM drive ejects the DVD.

Installation and Upgrade Guide for Cisco Unified MeetingPlace Express Release 1.1

 

OL-6665-04

4-11

 

 

 

Image 11
Contents Cisco MCS 7825 Series Servers Before You Start the InstallationCisco MCS 7835 Series Servers Server RAID enabled?Cisco MCS 7845 Series Servers Preinstallation WorkExit the Devices and I/O Ports menu by pressing Escape Enabling RAID on a Cisco MCS 7825-I1-RC1Enabling RAID on a Cisco MCS 7825-I2-RC1 OL-6665-04 Creating a Logical Drive on a Cisco MCS 7845-H1-RC1 Configuring the Cisco Unified MeetingPlace Express Server How to Install Cisco Unified MeetingPlace ExpressPrimary Secondary Domain Name Click Install Page OL-6665-04