Cisco Systems ONS 15540 Installing Line Card Motherboards and Transponder Modules

Page 17

Chapter 2 Quick Installation Procedures

Installing Cisco ONS 15540 ESPx Hardware

Table 2-7 Mux/Demux Motherboard LEDs

LED

Status

Description

 

 

 

 

 

Status

Blinking green

Motherboard has a good system clock from the primary

 

 

 

processor and is out of the reset state.

 

 

 

 

 

 

Solid green

Software initialization is successful.

 

 

 

 

 

 

Orange

System clock is not present. Board is unavailable.

 

 

 

 

 

 

Off

Board failure

 

 

 

 

 

Tx

Solid green

OSC is present and the optical laser output is enabled.

 

 

 

 

 

 

Off

OSC is not present and the optical laser output is disabled.

 

 

 

 

 

Rx

Solid green

OSC is present and the receiver is enabled.

 

 

 

 

 

 

Off

OSC is not present and the receiver is disabled.

 

 

 

 

 

 

 

 

 

Installing Line Card Motherboards and Transponder Modules

You can install up to eight hot-swappable line card motherboards in slots 2 to 5 and 8 to 11 of the Cisco ONS 15540 ESPx chassis.

Each line card motherboard holds up to four transponder modules that have a single protocol-transparent and bit-rate transparent external interface to the client side network and an internal interface that connects over the system's backplane to the mux/demux modules. The transponder modules are hot-pluggable, allowing in-service upgrades and replacement.

Transponders are available in single-mode and multimode. Line card motherboards are available with or without splitter protection.

Installing Line Card Motherboards

Perform the following procedure to install the line card motherboard:

Step 1 Remove the transponder side dust covers from the motherboard, and clean the optical connectors. See the “Cleaning Optical Connectors” section on page 2-28 .

Step 2 Insert the motherboard carefully into the chassis slot while guiding the upper and lower edges of the motherboard in the tracks until its connectors come into contact with the backplane.

Optical Transport Turn-Up and Test Guide

 

78-14964-01

2-17

 

 

 

Image 17
Contents Preparing to Install the Chassis Quick Installation ProceduresInstalling Strain Relief Brackets Installing the ChassisInstalling the Processor Card LED Connecting the Console Port Installing a Redundant Processor CardInstalling Mux/Demux Motherboards Installing Mux/Demux Motherboards and Mux/Demux ModulesInstalling 16-Channel Mux/Demux Modules Installing Line Card Motherboards and Transponder ModulesInstalling 4-Channel or 8-Channel Mux/Demux Modules Installing Line Card Motherboards Installing Extended Range Transponder Modules Installing SM Transponder Modules or MM Transponder ModulesCabling Mux/Demux Modules Cabling Transponder ModulesConnecting 4-Channel or 8-Channel Mux/Demux Modules Connecting Mux/Demux Module and OSC PortsPreparing to Install the Chassis Installing the Adapters in the Cross Connect Drawers Installing Cross Connect DrawersNME1 Installing the Vertical Cable GuidesInstalling the Redundant Processor Card Installing Mux/Demux Motherboards and Mux/Demux Modules Installing 32-Channel Mux/Demux Modules Installing Line Card Motherboards and Transponder Modules Installing SM Transponder Modules or MM Transponder Modules 10 Extended Range Transponder Module LEDs Cabling Mux/Demux Modules Opening the Cable Storage Drawer Cabling Directly with Cable Storage DrawersPull out the cable storage drawer -2 on Locking the Drawer Splitter Based Lcmb Non- Splitter Based Lcmb 6shows the cross connect drawer on the Cisco ONS 15540 ESPx Connecting Mux/Demux Modules and Transponder Modules Shelf Grounding ProcedureCleaning Optical Connectors Cleaning the ShelfPowering Up the Chassis Verifying the Power Up Verifying Installation of HardwareMA-MDXA-08D0

ONS 15540 specifications

Cisco Systems ONS 15540 is a high-capacity Optical Network System that plays a vital role in modern telecommunications by providing scalable and reliable transport solutions for service providers. Designed to accommodate the rapidly increasing demand for bandwidth, the ONS 15540 allows for seamless integration of voice, video, and data services over a single network infrastructure.

One of the standout features of the ONS 15540 is its ability to support both SONET (Synchronous Optical Network) and SDH (Synchronous Digital Hierarchy) protocols, enabling interoperability between different equipment and networks. This compatibility makes it an attractive solution for carriers looking to optimize their existing infrastructure while also preparing for future growth. The system is capable of delivering line rates of up to 40 Gbps, making it suitable for high-traffic environments.

The ONS 15540 employs advanced wavelength division multiplexing (WDM) technology, which allows multiple data streams to be transmitted simultaneously over a single optical fiber. This capability maximizes the utilization of existing fiber resources and significantly increases bandwidth availability. The system supports both CWDM (Coarse Wavelength Division Multiplexing) and DWDM (Dense Wavelength Division Multiplexing) configurations, offering flexibility to meet diverse network needs.

Another significant characteristic of the ONS 15540 is its modular architecture. This design enables service providers to easily upgrade and expand their systems by adding new line cards or service modules without significant disruption. The ONS 15540 accommodates various types of interfaces, including Ethernet, TDM, and video, ensuring the system can support a wide range of applications.

In addition to its hardware features, the ONS 15540 includes sophisticated management capabilities through Cisco's comprehensive management tools. These tools allow network operators to monitor performance, provision new services, and perform troubleshooting efficiently. With built-in redundancy and fault-tolerant features, the system ensures high availability and reliability, critical for service providers that require 24/7 operation.

In summary, the Cisco Systems ONS 15540 optical networking system provides a robust solution for carriers seeking to enhance their network capacity and flexibility. With its support for multiple protocols, advanced WDM technology, modular architecture, and management capabilities, the ONS 15540 stands out as a powerful asset for meeting the demands of today’s communication landscape.