Dell VRTX manual Turning On Server Modules, Installing The Optional Bezel

Page 8

Turning On Server Modules

Figure 10. Turning on a Server Module

Press the power button on each server module, or power on the modules using the systems management software.

NOTE: Make sure that the enclosure is powered on before you power on the server modules.

NOTE: The server modules do not power on until the CMC is properly configured and has fully initialized. It may take an additional two minutes for the server iDRAC to initialize after the chassis is fully powered on.

Installing The Optional Bezel

Figure 11. Installing the Optional Bezel

Install the bezel (optional).

Complete The Operating System Setup

If you purchased a preinstalled operating system, see the documentation associated with the operating system. To install an operating system for the first time, see the installation and configuration documentation for your operating system. Be sure the operating system is installed before installing hardware or software not purchased with the system.

NOTE: See dell.com/support for the latest information on supported operating systems.

8

Image 8
Contents Page Page Stabilizing The Tower System Unpacking The SystemLocating The System Electrical Rating Label Optional Rack Configuration Installing a Server ModuleConnecting The CMC Module Connecting The I/O ModuleConnecting The Optional Keyboard, Mouse, And Monitor Connecting The System To PowerSecuring The Power Cable Turning On The EnclosureTurning On Server Modules Installing The Optional BezelComplete The Operating System Setup Dell Software License Agreement Related Documentation NOM InformationPhysical Server Modules Technical SpecificationsPower Physical Enclosure Tower Configuration Rack ConfigurationEnvironmental Temperature Temperature Continuous OperationEnvironmental Relative HumidityMaximum Vibration Maximum ShockGaseous Contamination