Running EISA, RAID, and Other Configuration Utilities
4.3Restrictions When Running KZPSA Utilities
You must use V1.4 of the KZPSA Firmware Update Utility (FWUPDATE.EXE) if you wish to use it rather than LFU to update your KZPSA firmware. Note: running earlier versions of the KZPSA FWUPDATE.EXE utility will corrupt the NVRAM on your KZPSA and disable the module and your system!
Restrictions also exist if using the KZPSA CNFGDIAG.EXE utility. For one, you must use version V1.5 or greater on an AlphaServer 4100 system. The following release notes apply to V1.5 of the CNFGDIAG.EXE utility:
Table
Options
Reset SCSI Bus | The bus will be reset, but an error message will be displayed |
| after a timeout of about 1 minute on any subsequent reset |
| attempts. |
List devices | If the KZPSA SCSI ID is 15, the screen will clear rather than |
| wait for ’any key’. |