Compatible Systems V.35 manual Shipping Defaults, Ethernet Interface, WAN Interfaces

Page 15

Chapter 3 - Shipping Defaults

11

Chapter 3 - Shipping Defaults

Ethernet Interface

IP Routing Defaults

•On

•Address: 198.41.12.1

•Subnet Mask: 255.255.255.0

•Broadcast Address: 198.41.12.255

•IP RIP off

IPX Routing Defaults

•802.3 on, autoseeding

•802.2 on, autoseeding

•Type II on, nonseeding

•802.2 SNAP on, nonseeding

AppleTalk Routing Defaults

•Phase 1 off

•Phase 2 on, autoseeding

DECnet Defaults

•Off

WAN Interfaces

•Off

Image 15

Contents Octal V.35 10/100 Riop Installation Guide Page Quickstart Instructions Table of ContentsShipping Defaults Appendix a Connector and Cable Pin OutsLED Patterns Introduction to the Octal V.35-10/100 Riop Connecting the Octal V.35-10/100 to the Ethernet Network InstallationTelco Line Connection Requirements Connecting a Line Device to the V.35 InterfacesConnecting a Management Console Powering Up the RouterRequired for IP Ethernet Interface ConfigurationQuickstart Instructions IP ProtocolIPX Protocol AppleTalk ProtocolDECnet Protocol WAN Link Configuration WAN Interface ConfigurationPhysical Communications Settings PPP ConfigurationFrame Relay Configuration Required for IP Unnumbered Interface Frame Relay Dlci MappingsRequired for Dedicated Line Operation Required for IP Numbered InterfaceSuggested for IP Smds Addressing Smds ConfigurationSaving a Configuration File to Flash ROM Link ConfigurationShipping Defaults Ethernet InterfaceWAN Interfaces LED Patterns Pin Outs for HD D-Sub Male to V.35 Male Cable Appendix a Connector and Cable Pin Outs