Compatible Systems V.35 Shipping Defaults, LED Patterns, Appendix a Connector and Cable Pin Outs

Page 4

Table of Contents
Required for IP Unnumbered Interface	8
Suggested for IP	9
IPX Protocol	9
Required for IPX	9
Suggested for IPX	9
AppleTalk Protocol	9
Required for AppleTalk	9
Suggested for AppleTalk	9
DECnet Protocol	10
Required for DECnet	10
SMDS Configuration	10
Link Configuration	10
SMDS Addressing	10
SAVING A CONFIGURATION FILE TO FLASH ROM	10
Chapter 3 - Shipping Defaults	11

Ethernet Interface	11
IP Routing Defaults	11
IPX Routing Defaults	11
AppleTalk Routing Defaults	11
DECnet Defaults	11
WAN Interfaces	11
Chapter 4 - LED Patterns	12

Over Temp	12
Sys Ready	12
General Indicators	12
Ethernet Traffic Indicators	12
V.35 Traffic Indicators	12
Ethernet Connection Indicators	12
Appendix A - Connector and Cable Pin Outs	13

Pin Outs for HD D-Sub Male to V.35 Male Cable	13

ii

Image 4

Contents Octal V.35 10/100 Riop Installation Guide Page Table of Contents Quickstart InstructionsAppendix a Connector and Cable Pin Outs Shipping DefaultsLED Patterns Introduction to the Octal V.35-10/100 Riop Network Installation Connecting the Octal V.35-10/100 to the EthernetConnecting a Line Device to the V.35 Interfaces Connecting a Management ConsolePowering Up the Router Telco Line Connection RequirementsEthernet Interface Configuration Quickstart InstructionsIP Protocol Required for IPAppleTalk Protocol IPX ProtocolDECnet Protocol WAN Interface Configuration Physical Communications SettingsPPP Configuration WAN Link ConfigurationFrame Relay Configuration Frame Relay Dlci Mappings Required for Dedicated Line OperationRequired for IP Numbered Interface Required for IP Unnumbered InterfaceSuggested for IP Smds Configuration Saving a Configuration File to Flash ROMLink Configuration Smds AddressingEthernet Interface Shipping DefaultsWAN Interfaces LED Patterns Appendix a Connector and Cable Pin Outs Pin Outs for HD D-Sub Male to V.35 Male Cable