Belkin F1DP116SEA Network IP Config, Network Current IP, Network IP Filter, System Reboot

Network Configuration

Network > IP Config

The page to the left shows the IP configuration items.

1.For IP mode — You can press the SPACE bar to select Static mode or DHCP mode.

2.For IP Address, Subnet Mask, Default Gateway, Primary DNS, and Secondary DNS — You can change these network settings.

3.After changing the settings and the final enter, the Console Server will prompt you to confirm YES or NO. If YES, the Console Server will reboot and save the settings into the flash memory.

Network > Current IP

To show the current network settings.

Network > IP Filter

To enable/disable IP filter function.

System > Reboot

To reboot the Console Server.

System > Reset to Default

To reset configuration to factory-default settings.

Note: Only the admin user has the privilege to perform this function.

System > Status

To show the system status.

S-to-S > Select Serial-to-Serial Port

To enable serial port-to-serial port connection through port 16. Refer to the “Serial-to-Serial Function” section on page 34 for more details.

section

15