Bunn CT, CWTF service manual Coffee Brewing, HOT Water Faucet

Page 14

COFFEE BREWING

1.Insert a BUNN® filter into the funnel.

2.Pour the fresh coffee into the filter and level the bed of grounds by gently shaking.

3.Slide the funnel into the funnel rails.

4.Place an empty dispenser beneath the funnel.

5.Place the "ON/OFF" switch in the "ON" upper position. Momentarily press and release the start switch.

6.When brewing is completed, simply discard the grounds and filter.

HOT WATER FAUCET

The hot water faucet may be used to dispense a cup of hot water at any time. Not intended for filling carafes, pitchers, etc. Attempting to dispense more than 8-10 ounces will result in cool water. NOTE – Faucet will not work with the pour in feature, brewer must be plumbed to a working water supply line.

Page 14

41721 111308

 

Page 13 Page 15
Image 14
Page 13 Page 15
Contents CT, Cwtf Series Phone 217 529-6601 FAX 217BUNN-O-MATIC Commercial Product Warranty Introduction Explanation of codesUser Notices Brewer is ready for Initial Set-Up Electrical HOOK-UPTerminal blocks Plumbing REQUIREMENTS-CURRENT Singles Model CPlumbing REQUIREMENTS-CURRENT Twins TwinsPlumbing REQUIREMENTS-EARLY Singles Plumbing REQUIREMENTS-EARLY Twins Adjusting Brew Volumes Initial SET-UPThermostat Thermostat KnobFlip LID Pour in Feature ON/LOWER SwitchStart Switch Operating ControlsTank Heater ON/OFF Switchs Late Model Switchs Early Model SwitchsMaster ON/OFF Switchs Coffee Brewing HOT Water FaucetCleaning Troubleshooting Problem Probable Cause RemedyFunnel Sprayhead ProperlyWeak beverage
Top Page Image Contents