User Notices

Carefully read and follow all notices in this manual and on the equipment. All labels on the equipment should be kept in good condition. Replace any unreadable or damaged labels.

As directed in the International Plumbing Code of the International Code Council and the Food Code Manual of the Food and Drug Administration (FDA), this equipment must be installed with adequate backflow prevention to comply with federal, state and local codes. For models installed outside the U.S.A., you must comply with the applicable Plumb- ing /Sanitation Code for your area.

#00656.0001

#03408.0002

#03409.0002

Optional Field Wiring

#00658.0000

To reduce the risk of electric shock, do not remove or open cover.

No user-serviceable parts inside. Authorized service personnel only. Disconnect power before servicing.

#37881.0000

!WARNING

Fill water tank before turning - on - thermostat or connecting appliance to power source.

Use only on a properly protected circuit capable of the rated load.

Electrically ground the chassis.

Follow national/local electrical codes. Do not use near combustibles.

FAILURE TO COMPLY RISKS EQUIPMENT

DAMAGE, FIRE, OR SHOCK HAZARD

READ THE ENTIRE OPERATING MANUAL

BEFORE BUYING OR USING THIS PRODUCT

THIS APPLIANCE IS HEATED WHENEVER

CONNECTED TO A POWER SOURCE

#00831.0000

CAUTION WARMERS AND SURFACES ARE HOT

#02765.0000

Optional Field Wiring

120/208-240 V, 11.4-13.1 A, 2340-3100 W

1PH, 3-Wire + GND, 60HZ

120/208-240 V, 12.25-13.9 A, 2440-3200 W

1PH, 3-Wire + GND, 60HZ

#34955.0000

APS MODELS

Optional Field Wiring

120/208-240 V, 13.0-14.8 A, 2540-3300 W

1PH, 3-Wire + GND, 60HZ

#34955.0001

ONE WARMER MODELS

Optional Field Wiring

120/208-240 V, 13.9-15.6 A, 2640-3400 W

1PH, 3-Wire + GND, 60HZ

#34955.0002	#34955.0003
TWO WARMER BREWERS	THREE WARMER BREWERS
	120V
	120/208-240V
	#34056.0000

#12364.0000

VOLTAGE SELECTOR SWITCH

Page 4	41721 080310