Silex technology setup guide SX-600 User’s Manual

Page 9

5.You should see the SX-600 in the list. If you do not see the SX-600 in the list, start again and verify all the steps were made correctly for the installation up to this point again. Right-Click the SX-600(where the H/W address matches the one on the back label of the SX-600) and click Configuration.

6.The IP Address settings of the SX-600 are for configuration purposes only. These will not effect the network device you are connecting to. You do not normally need to change these settings if you want to continue to make future configuration changes by connecting directly from a PC with a crossover Ethernet cable.

SX-600 User’s Manual

9

Image 9

Contents Ethernet to Wireless Client Adapter Setup GuideSX-600 User’s Manual Table of Contents Introduction Package ContentsWindows System Requirements Other Operating SystemsSX-600 Installation Wireless RequirementsConfigure the Network Settings on your Computer Select Internet Protocol TCP/IP and click Properties ExtendView for Windows Configure the SX-600SX-600 User’s Manual Mode Configure Bridge viaPassword Authentication TypeKey Selection WEP KeyCertificate Common Name Authentication ProtocolCertificate Root Key Certificate Root Key ExponentSX-600 User’s Manual Web Browser Interface Command Line Console ConfigurationSerial Port TelnetConnecting to your network enabled device Verifying Succesful InstallationTroubleshooting SX-600 User’s Manual LED Function Rear Button FunctionReturning Products Where to Get HelpInformation for United States Users Safety and Regulatory NoticesInformation for Canadian Users IC notice Declaration of Conformity FCCSuccessful communication Declaration of Conformity CE Information for European Users